The BeagleBoard is a low-power open-source single-board computer produced by Texas Instruments in association with Digi-Key and Newark element The BeagleBoard was also designed with open source software development in mind, and as a way of demonstrating the Texas Instrument's OMAP system-on-a-chip. It is also sold to the public under the Creative Commons share-alike license. Because of the low power consumption, no additional cooling or heat sinks are required. The BeagleBoard-xM measures in at The addition of the Camera port to the -xM provides a simple way of importing video via Leopard Board cameras.

Author:Arashizragore Mak
Language:English (Spanish)
Published (Last):28 December 2005
PDF File Size:4.77 Mb
ePub File Size:8.37 Mb
Price:Free* [*Free Regsitration Required]

Designed with the community inputs in mind, this open hardware design improves upon the laptop-like performance and expandability, while keeping at hand-held power levels. They can be used to repair corrupted cards or to create a backup version of the cards. They require a 4GB SD card for the image to fit. These are full desktop images. Download and install Ubuntu's Win32DiskImager also known as the winimage-writer.

Download and install 7-zip compression software. Download the SD card image you want to use listed below. These are the images that ship with the boards. Download the HP Formatting tool from one of the following locations. These versions are 2.

The previous version that you could download was 2. FAT has been dropped from version 2. Decompress the verification image file using 7-zip. If this a fresh card, one that has never been used, you can skip to step Close the HPFormatter tool when done. Start the Win32DiskImager. Select the decompressed image file and correct SD card location. Click on 'Write'. After the image writing is done, eject the SD card. NOTE: If you are trying to reuse an SD card that has already been used under the above process, you will need to reformat the card to erase the second parttion.

To initialize your card under Linux , refer to the link to the Angstrom Demo Site. Follow the instructions found there, but use the images located on this site. Either of these images can be used. But, the prefered one is the production version which is the one we are currently shipping. These file were created using 7-zip. It is recommended that you use 7-zip when unzipping these files. The file below contains below contains the checksum for both the ZIP file and the uncompressed image.

The files below are the files that can be used to build your own version of the BeagleBoard hardware and to modify as you choose. To view the PCB files, a free viewer can be downloaded from Cadence. You can use this to make measurements, check dimension on the PCB, and look at each layer to analyze the routing used.

You can download the file at Allegro Viewer. NOTE: Only one change was made for this revision. There are no functional differences as a result of this change. The schematic and PCB remain the same as revision C1. The pads on the expansion headers wee beefed up to address some issues we were seeing where there was a disconnect between the etch and the pads inside the PCBs. The schematic and bill of materials remain the same as revision C. To download all files at once please click here.

From eLinux. Jump to: navigation , search. Navigation menu Personal tools Log in Request account. Namespaces Beagleboard Discussion. Views Read View source View history.

This page was last edited on 2 April , at Privacy policy About eLinux.










Related Articles