ASTM E2112 - 07 PDF

This document has been replaced. View the most recent version. For the purpose of this practice, fenestration products shall be limited to windows, sliding patio-type doors, swinging patio type doors, and skylights, as used primarily in residential and light commercial buildings. This practice attempts to educate the installer, builder, architect, and other users in the identification and understanding of the water shedding system of the building envelope.

Author:Nikokree Mezikus
Country:Yemen
Language:English (Spanish)
Genre:Finance
Published (Last):2 October 2015
Pages:416
PDF File Size:10.9 Mb
ePub File Size:19.16 Mb
ISBN:504-9-27573-972-4
Downloads:63536
Price:Free* [*Free Regsitration Required]
Uploader:Mezilmaran



Active view current version of standard. Other Historical Standards. Work Item s - proposed revisions of this standard. More E For the purpose of this practice, fenestration products shall be limited to windows, sliding patio-type doors, swinging patio type doors, and skylights, as used primarily in residential and light commercial buildings. This practice attempts to educate the installer, builder, architect, and other users in the identification and understanding of the water shedding system of the building envelope.

It does not cover the fabrication or assembly of multiple units, whether such fabrication takes place in a factory or at the intended installation site. The installer should check with the manufacturer of factory-assembled units for instructions for anchoring.

When using field-mulled units, follow manufacturer's recommendations and make certain that they meet applicable codes. This practice does not cover the selection of appropriate fenestration products for a given application, nor the selection of other products or systems for use in the installation. Actual conditions in buildings vary greatly and, in some cases, substantial additional precautions may be required.

In the event that the manufacturer's installation instructions provided with the product conflict with requirements of this practice, the manufacturer's instructions shall prevail. This practice is not intended to limit or exclude other new procedures that may refine or further improve the effectiveness of fenestration installation.

Further, this practice attempts to consolidate and unify the various steps of construction, tying together the various trades involved with the continuity between fenestration products and the building envelope. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this practice. The values shown in parentheses are for information only. Furthermore, this practice does not purport to provide fail-safe installation methods, assurance or protection against installation deficiencies, or a standard by which architects can specify or ensure delivered performance.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 5, Related Procedures. Where an asbestos hazard is known or suspected, refer to the ASTM Manual on Asbestos Control , and to applicable state and federal regulations. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

B Specification for Electrodeposited Coatings of Cadmium. Scope 1. Note 1—There are no ISO standards covering the primary subject matter of this practice. Link to Active This link will always route to the current Active version of the standard.

DN C640 PDF

ASTM E2112-07: Standard Practice for Installation of Exterior Windows, Doors and Skylights

Historical Version s - view previous versions of standard. Work Item s - proposed revisions of this standard. More E The general contractor shall be responsible for the necessary coordination of trades and proper construction sequencing of the installed fenestration product. It may promote the deterioration of wall constructions, insulation, fenestration products, and their respective finishes.

ACOPOS 1320 PDF

Popular Publishers

.

1.4.1325 EDITOR FOXIT PDF

.

INVESTOOLS ADVANCED OPTIONS PDF

.

Related Articles